Take the clock, the pendulum, and key carefully out of the carton.

Open the door of the clock's case. Carefully remove the protective packaging such as foam rubber, corrugated paper, rubber bands, etc. You will find the material where the hammers are; underneath the movement as well as at the end of the pendulum leader and around the chime rods. Save the packing in case the clock needs to be returned.

Hang up the clock so that it is vertical. The safest way to hang the clock is a wood screw angled upward and screwed into a stud in the wall.

Please wind your clock fully every seven days for optimum performance (the clock will run about 8 - 9 days on one winding). To wind the clock, use the enclosed key. Turn key clockwise until it stops (about 3 1/2 turns on the left winder and about 4 1/2 turns on center and right winder. The center winder is for the timekeeping, the right winder is for the quarter-hour chime, and the left winder is for the hour strike.

Hang the pendulum onto the pendulum leader (see image below)

Move the pendulum slightly to the left or right and release it gently. You should hear an even "tic - toc" sound. If the tic-toc is uneven or the clock stops, follow the "putting in beat" procedure.

Putting the clock in beat is the responsibility of the clock owner. While the clock was in beat when it left the factory, it may get out of beat during handling. To put the clock in beat: Make sure the clock is hanging straight. Listen to the tic toc. Gently push the pendulum leader slightly past the point of resistance. Listen to the tic toc again. If it is more uneven, push the leader in the opposite direction and listen to the tic tock again. After several tries, you will be able to get the tic and toc sound to be evenly spaced, and the clock is then "in beat."

The chime shut-off lever is located to the left of the numeral 9. Turn the lever down if you want the clock to be silent

The minute hand (long hand) may be moved clockwise or counterclockwise to set the clock to the correct time. Never turn the hour (short) hand, it moves automatically. After two hours, the chimes will be automatically synchronized.

If the clock is striking the wrong hour, move the hour hand (short hand) to point to the hour that the clock just struck.

To make the clock run slower - turn the regulating nut below the pendulum to the left 

To make the clock run faster - turn the regulating nut to the right.

One turn of the regulating nut changes the clock's rate by approximately 1 minute per day. It is normal for a clock to run a few minutes fast or slow per week.